PeerTrigger + PeerADSR = sort of compressor/expander
Posted: Thu Mar 28, 2013 11:10 pm
- compression/expansion and dynamics in ways that are silly
- stuff like putting a lopass filter to more quiet parts of a single drum hit (and vice versa)
- replace and use PeerADSR on other effects such as pitch effects, distortion or whatever can be "enveloped"
- maybe use this as a drumloop editor or even build more complex structures to completely change drumloops
What's happening ???
- LdC Automax: move reset to normalise input
- Bigyo Delay: sound is delayed by 11 ms so that peercontrollers aren't too slow to cause clicks
but it's difficult to remove them completely
(LD transient can eventually remove some clickyness. It's there in bypass mode)
(to get rid of the delay: add a Bigyo Delay with the same settings to other outputs)
- Peertrigger: to trigger PeerCtrl and send 1 trigger to 3 channels of PeerADSR
- p. ADSR ch.0: 1 PeerADSR channel for 1 Cheapo amp
- p. ADSR ch.1: 1 PeerADSR channel for 1 Cheapo amp + Bigyo 2p filter
- p. ADSR ch.2: 1 PeerADSR channel for 1 Cheapo amp to control the above 2
- sequencer: one PeerADSR for envelopes, and one for Min/Max and p. ADSR ch.2
- rightclick PeerADSR in machineview to add more custom envelopes
- custom envelopes: high = dry, low = wet (and/or filtered) (except when min/max are turned around)
- simplifying idea: set both Min and Max of other PeerADSR channels to the same value (to make them
put out a dry or static signal, so that you know better what you are doing
- adjust Peertigger's beatsensitivity and reset LdC Automax for other sounds.
Peer LFO, Oomek Exciter, LD transient and Joachims Limiter are optional.
... and ofcourse if you understand all this you would make your own automation etc ...
this is a complex example.
a template by Vacuum, inspired by a template on buzzmachines.com by Mute