I must be daft, because whatever I'm missing is probably obvious.
So, I dropped Snapshot 1.2 into my "Live" setup (which admittedly is full of many machines & 1464 properties according to Snapshot
). I then selected 4 of the machines (Jeskola Delay; IX Patchbay 7x7; FreeAmp 2.5 (a VST) & Sonic Verb - for a total of 98 Properties selected), all of which are the machines whose parameters I would like to capture changes with Snapshot. I selected Slot 0 in the Main tab, hit the <Capture> button, made sure the values captured were correct in the treeview, then I selected Slot 1, changed the settings on those 4 machines, hit <Capture> again, & again verified that the values captured were correct (they were).
But now switching between the two Slots (0 & 1) changes the values displayed in the treeview in Snapshot; but does not change the parameter values in the machines themselves. I have tried switching Slots both with the Dropdown Menu in the Main Tab as well as in the Manage Tab; & I have also tried switching slots using the Slot parameter slider at the bottom of the Snapshot parameter window. Everything within Snapshot changes as expected, however the parameters in the captured machines themselves do not change.
I'm sure I'm missing something obvious. That's usually where I stumble
Any help would be greatly appreciated
See You In The Shadows…
p.s. Ok, I did just figure it out. I am daft (as I said)
I need to hit the <Restore> button after I select the desired Slot. I guess there isn't a way to have the <Restore> function happen automatically when you select a Slot in either the Dropdown menu or via the parameter slider… That's a little more intuitive, for me at least. But I did get it to work, so disregard the above
(I told you it was going to be obvious
p.p.s. This is awesome IX. Makes my shoegazing life so much easier now
p.p.p.s. (There's a lot of p happening in this post, sorry…
) I guess I could combine the Slot selection function & maybe the <Restore> function using Peer Control? Hopefully? Gonna experiment…