buzz forums

Hello!

Stuck with my studies in PeerLFO. Hope someone can help me. Again...

I'm trying to make Ninja delay lengthparameter add +1 to its value from 1 to 1024 via PeerLFO.

I could hack the values in o the pattern but this sounds more convenient if I can learn it.

I've set LFO min to 0000 and LFO max to 3,12% which equals 1024 on Ninja delay lengthparameter.
I've also set manual phase to 0000.... is this wrong?


Now, where do I go from here? No matters how I pull sliders I can not get PeerLFO to control the delay in the right pace. Actually I can't get it to move slow enough. Perhaps this is because the short span 0-3,12% demands a rate slower than Peerlfo can offer?


Thankful for all help!
Anders

Ah!
Finally it works. Tried I tried this before I posted question but then I didn't get the result I wanted.

Wave shape "Ramp down and up" and rate at max (4095 14/16) works. I guess I should have used 4096 0/16 for optimal result but FFFE is max.